Page 5
FiberLink Beamer-V™ User’s Manual
FiberLink Beamer-V™
The following instructions describe the typical installation procedure:
1 . Mount the Beamer-V transmitter at the camera or source of video to be transmitted .
Use the mounting tabs on the housing or the enclosed selfadhesive mounting pad .
2 . Connect one of the plug-in power supplies to the input connector on the Beamer-V
transmitter . If an external power source is to be used, be certain it provides regulated
12 volts DC+10% . Current from this source will not exceed 250 ma . When power is
applied, the red PWR indicator LED will glow . Note that the (-) side of the power input
is connected to the enclosure .
3 . On the Beamer-V transmitter, connect the video signal to be transmitted to the BNC
connector and the ST fiber optic cable plug to the optical connector .
4 . Mount the Beamer-V receiver at the monitor or device where the video will be
received .
5 . Connect the remaining plug-in power supply to the Beamer-V receiver’s input
connector . If an external power source is to be used, be certain it provides regulated
12 volts DC +10% . Current from this source will not exceed 250 ma . When power is
applied, the red PWR indicator LED will glow . Note that the (-) side of the power input
is connected to the enclosure .
6 . Connect the video monitor or other video receiving device to the BNC connector
on the Beamer-V’s receiver and the fiber optic cable plug to the Beamer-V receiver’s
optical connector .
7 . For a pleasing picture, slowly adjust the LEVEL control on the Beamer-V’s receiver . If
high accuracy is required, set this level to 1 volt pp with a 75 ohm load .
8 . Your Beamer-V video transmission system is now installed .
Installation Instructions
