Artel FiberLink 1302 Series, Инструкция по установке и эксплуатации, Страница: 4 / 8

Page 4 1302 Series User’s Manual
1302 Series
Installation Instructions
1 . Connect the provided 6 ft . VGA cable to both the VGA output of the computer and the
connector on the rear of the splitter marked VGA IN . (If your VGA monitor is currently con-
nected to the VGA output of the computer, you must first disconnect it .)
2 . Connect your primary monitor (the one you just disconnected) to the output on the rear
of the splitter marked MONITOR 1 .
3 . Connect the additional monitor(s) to the remaining monitor outputs on the rear of the
splitter . Monitor extension cables (CAB-19) may be used to extend the distance up to 250
feet . (See Cable Length Support section on opposite page .)
4 . Plug the power supply into the jack on the rear of the splitter marked POWER .
5 . Plug the power supply into a 110 Vac or 220 Vac wall outlet as appropriate . The front
panel LED should glow red indicating the unit is properly powered .
6 . Turn on the computer and the monitor(s) . All monitors will now display the computer’s
output .
7 .
Make sure all monitor type DIP switches are in the UP

position. This will ensure that
the monitor ID bits are read from the monitor plugged into MONITOR 1 . If you want to
explicitly set the monitor type ID bits, either because no monitor is plugged into this output
or because the monitor plugged into MONITOR 1 is connected through an extension cable
that does not convey the monitor ID bits, then set the DIP switch as indicated on Chart 1 .
Cable Length Supported:
The maximum distance a monitor can be from the splitter output will depend on the
quality of the extension cable being used and the pixel resolution of the VGA image coming
from the computer . Never use twisted pair cable for monitor extension cable as this will cause
“ghosting” to be seen on the monitor. Chart 2 lists maximum cable length support of CSI’s
CAB-19 cable at various VGA resolutions .
Troubleshooting
If one or two colors are missing on one of the VGA monitors, make sure all connections to
the splitter are secure by tightening the connectors . If you experience any other difficulties
or have further questions, we provide free technical support Monday through Friday, 8:30-
5:00 ET, at (978) 263-5775 .
Installation | Cable Length | Troubleshooting