Artel DigiLink DLC150E, Инструкция по установке и эксплуатации

Страница: 30 / 36

20 DLC150E Function Module Installation and Operations Manual
DLC150E Function Module
Using the Monitor Jack
To connect a monitor the DLC150E to view the transmit and receive signals, perform the following steps:
1. Connect the monitor cable between the monitor and the mini 75 Ohm SMB monitor jack (MON) located
on the DLC150E front panel (see Figure 10 ).
2. Switch the monitor select switch to the desired position:
• IN—View the digital video source
• OUT—View the digital video that the DLC150E is transmitting
Removing the SFP and DLC150E Module
You can safely remove either the SFP from the DLC150E or the DLC150E from the host chassis while power is
applied to the module.
This section contains the following topics:
• Removing the SFP (page 20)
• Removing the DLC150E Module (page 21)
Removing the SFP
To remove the SFP from the DLC150E, perform the following steps:
1. Remove the fiber optic cables from the SFP.
2. Pull down on the SFP handle to dislodge the SFP from the DLC150E.
3. Using the SFP handle, pull the SFP out of the DLC150E.
Figure 11. Removing the SFP
SFP handle