11
Ordercode: A0720077/A0720078/A0720079
Amaro 100W COB LED IP65
Maintenance
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by an expert after every year in the course of an acceptance test.
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by a skilled person once a year.
The following points have to be considered during the inspection:
01)
All screws used for installing the device or parts of the device have to be tightly connected and
must not be corroded.
02)
There may not be any deformations on housings, fixations and installation spots.
03)
The electric power supply cable
(use only H05RN-F 3x1.0mm2 power cables)
must not show any
damages or material fatigue.
The Amaro 100W COB LED IP65 requires almost no maintenance. However, you should keep the unit
clean. Otherwise, the fixture’s light output will be significantly reduced. Disconnect the mains power
supply, and then wipe the cover with a damp cloth. Do not immerse in liquid. Wipe lens clean with glass
cleaner and a soft cloth. Do not use alcohol or solvents.
The front lens will require weekly cleaning, as smoke-fluid tends to build up residues, reducing the light-
output very quickly.
Please clean internal components once a year with a light brush and vacuum cleaner.
Keep connections clean. Disconnect electric power, and then wipe the connections with a damp cloth.
Make sure connections are thoroughly dry before linking equipment or supplying electric power.
Troubleshooting
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit
operates properly, do not carry out following steps.
No Light
If the light effect does not operate properly, refer servicing to a technician.
Suspect two potential problem areas as: the power supply and the LEDs.
01)
Power supply. Check that the unit is plugged into an appropriate power supply.
02)
The LEDs. Return the Amaro to your Artecta dealer.
03)
If all of the above appears to be O.K., plug the unit in again.
04)
If you are unable to determine the cause of the problem, do not open the Amaro, as this may
damage the unit and the warranty will become void.
05)
Return the device to your Artecta dealer.
Problem
Probable cause(s)
Solution
The fixture does
not function at all
No power to the fixture
•
Check if power is switched on and
cables are plugged in
Internal fuse blown
•
Return the device to your local
Artecta dealer
Bad cable connection
•
Inspect connections and cables.
Correct poor connection. Repair
or replace damaged cables.
No light or lamp
cuts out
intermittently
Fixture is too hot
•
Allow the fixture to cool down
•
Turn up the air conditioning
LEDs damaged
•
Disconnect the fixture and return it
to your dealer
The power supply settings do not
match local AC voltage and
frequency
•
Disconnect fixture. Check settings
and correct if necessary