arsenalmod.com
Page 9 of 14
J5 and J6 Connections
7.
On the reverse side of to PCB, solder wires to the legs of connectors J5 and J6. For J5, all D-pad connections,
Sync and LB need to be connected. Cut wire to the correct length to keep the install clean.
When connecting to the legs of the J5 and J6 connectors, apply some solder to the legs first. Then introduce
the wire to the leg while heating the solder. Remove soldering iron after wire has made the connection to
the leg. Using a multimeter, you can check if the connection is made by checking the resistance is 0 ohms
from the top of the connector, and the other end of the wire. If your multimeter has the connection check
option, you will hear a “beep” if the connection is made.
Up
Right
Left
LB
Down
Sync
