Arrowhead Alarm Products ESL-2, Инструкция по установке и программированию

Страница: 37 / 136

37
ESL-2 Keypad Display & Brightness
ESL-2 Keypads
Display & Brightness
KP-TOUCH
• Press the ‘ Settings ’ tab at the bottom right of the home screen
• Now press ‘ My Settings ’.
• Enter a valid user code followed by the ‘ ENTER ’ button
• Scroll down and press option ‘ 10. Display & Brightness ’.
• Adjust your display and screen saver brightness as desired, then press the ‘ BACK ’
button to exit to the home screen
KP-ICON-OEM
• From the home screem, press ‘ PROG ’, then ‘ BYPASS ’, then ‘ENTER’. The display should now
read ‘LPGM’
• Now press ‘
PROG ’, then ‘ 904 ’, followed by the‘ ENTER ’ button. The display should now read
‘ B/L ’
• Adjust the brightness with the Up / Down arrows, then press ‘ ENTER ’ to confirm your desired
brightness level.
• Once complete, press ‘ PROG ’ followed by ‘ ENTER ’ to return to the home screen.
KP-LCD-ST7OEM
• Press and hold the ‘ CONTROL ’ button, then within 2 second (while still holding the
‘ CONTROL ’ button) adjust the brightness with each press of the Left / Right arrows.
Sensor Naming
KP-ICON-OEM does not support this feature.
KP-TOUCH
• Press the ‘ Settings ’ tab at the bottom right of the home screen
• Now press ‘ My Settings ’.
• Enter a valid user code followed by ‘ ENTER ’.
• Scroll down and press option ‘ 5. Sensor Names ’.
• Use the Left / Right arrows to select the sensor you wish to name.
• Enter the new sensor name using the keypad, followed by the ‘ ENTER ’ button to
confirm. Press the back button to return to the home screen.
• The new sensor name will be displayed under the ‘
Sensors ’ tab on the home screen.
KP-LCD-ST7OEM
• Enter local programming by holding the ‘ CONTROL ’ button and within 0.5 seconds,
also hold the ‘ ARM ’ button for 5 seconds.
• When ‘Local Mode KB’ is displayed press ‘ PROG ’, then the sensor number you wish
to change followed by ‘ ENTER ’ to confirm.
• Enter the sensor name using the alphanumeric keypad and Left/ Right arrows to
navigate, then press ‘ENTER’ to confirm. Repeat the steps above for each sensor.
• Once complete, press the ‘ PROG ’ button until ‘Exit Programming’ appears on the
screen. Then press ‘ ENTER ‘.