5
2
Installing the Microforce Joystick
2.1
Preparation
NOTE
Unscrew and remove the joystick handle first.
2.2 Dismantling the bottom cover
NOTE
A T10 Torx screwdriver is needed
for the next steps.
Turn the panels over and remove
the six Torx screws.
2.3 Disconnecting cables
Disconnect the BLUE and BLACK cable
slowly and carefully.
DANGER
Do not pull on the cable!
Pull the white connector to disconnect.
2.4
Dismantling the joystick panel
NOTE
A T10 Torx screwdriver is needed for the
next steps.
Remove the 4 screws of the joystick cover.
2.5 Removing the existing joystick
NOTE
Carefully lift the existing joystick out of
the control panel.
2.6 Placing the Microforce Joystick
Note the contour of the joystick cover and insert
the joystick in the control panel according to its shape.
Place the four Torx screws and tighten them.
Installation
Disconnect any power supply from the remote panel!
CAUTION
Torx
screws
Torx
screws
