2
DISASSEMBLY/ASSEMBLY INSTRUCTIONS
RIGHT–ANGLE SECTION
DISASSEMBLY
a. Remove lock screw (32788–ARO) and drive shaft (37487)
with bearing and gear attached.
b. To remove bearing (41093), remove nut (32798) and gear.
c. Loosen nut (32795) completely and remove drive shaft
(41543) with attached parts. To remove from shaft, remove nut
(32798).
ASSEMBLY
a. Assemble nut (32975), seal (32796), spacer (32797), bearing
(41093) and gear to shaft (41543) and secure with hex nut
(32798). Assemble into housing and secure to housing with
nut (32795).
b. Assemble bearing (41093) and gear to shaft (37487) and se-
cure with nut (32798). Assemble into housing and secure to
housing with lock screw (32788–ARO).
NOTE: Seal (32796) must be assembled to shaft with lip of seal
facing bearing. Bearings (41093) are shielded on one side. Bear-
ings must be assembled to shafts, shielded side first. Right–angle
assembly should contain 1/8 oz. of grease.
RIGHT–ANGLE ASSEMBLY 41544
(ATP–19)
GEARING SECTION
GEARING ASS’Y 37485
(7.43:1)
(ATP–52)