It is recommended to clean the threads and O-ring off dirt and old grease. Remember that secure protection from water and
dust cannot be provided by worn out sealing. And fouling as well as lack of lubricant cause fast wear-out of threads and
sealing rings.
To clean the threads do the following:
1. Unscrew the tailcap and remove the sealing ring carefully with a toothpick (do not use sharp metal things as they can
damage the ring).
2. Wipe the sealing ring thoroughly with a soft cloth (or tissue). Do not use solvents. If the sealing ring is worn out or
damaged replace it by a new one.
3. Clean the metal threads with a brush using ethanol. Be careful not to allow applied liquid to get inside the flashlight or
tailcap as it can cause fails in functionality of the flashlight.
After cleaning lubricate the thread and the sealing ring with polyalphaolefin-based silica grease, e.g. Nyogel 760G.The
application of automotive and other improper grease can cause swelling and damage of the sealing rings.
In case of active operation and exploitation in dusty environments, it is recommended to perform cleaning and lubricating of
the parts as often as required, even if it is more than twice a year.
With ambient temperature is +25..+30°C the headlamp delivers light in Maximal mode for about 5-7 minutes and then the
brightness steps down to the Main3 mode. 10-60 seconds afterwards the brightness increases to the Maximal level again.
This stepping goes cyclically to maintain the user's safety and the headlamp's functionality. In the conditions of good air-
cooling the headlamp produces constant light even in Maximal mode.
Armytek Optoelectronics Inc. shall not be liable for any harm done to the user if it was caused by
improper use of the product.
1. Always follow the instructions from this manual and recommendations on battery usage.
2. Apply only the recommended power sources.
3. Do not reverse battery polarity.
4. Do not use different power sources together, i.e. old ones with new ones, charged with
discharged. Do not use different types of batteries combined as the element with less
capacity can be damaged.
5. Do not modify or recast the flashlight and its components as it will deprive you of the
warranty.
6. Do not allow water or any other liquid to leak into the flashlight.
7. Do not aim a turned-on flashlight at people's or animals' eyes — it can cause temporary
blindness.
8. Do not allow children to use the flashlight without your assistance.
Care and Storage
Born to exceed.
The most technically advanced flashlights in the world.
Operation
Warnings
Armytek Tiara
USER MANUAL
Thank you for choosing the products of Armytek Optoelectronics Inc., Canada.
Please read this manual carefully before using the flashlight.
www.armytek.com
The most technically advanced flashlights in the world
.
Born to exceed.
For comfortable opera on you have a convenient
momentary access to all the following Modes:
Main.
Click the bu on in OFF-state. Press and hold — to switch main modes in a cycle, and release — to select one.
off
on (main)
main 1
main 2
main 3
Maximum
Main
Main
on
max
x2
Firefly
firefly
main 1
firefly
off
Firefly
firefly
main 1
off
main 2
main 3
max
x
1
Maximum.
Double click in Main mode for persistent ac va on (returns with another double click).
Firefly.
Press and hold in OFF-state to ac vate. Release — for selec on. Double click — returns to the Main
1
mode. If
press and hold a er Firefly ac va on, the headlamp will go through the 3 main modes, then Maximum and turn off (as
the protec on from accidental switching in a bag or pocket will work out).
Automemorizing.
A er switching off the last used Mode is memorized for quick 1-click access at next switching on.
Warning Indica on.
In ON-state shows the ba ery voltage and the temperature inside the headlamp.
The voltage. When it drops the main LED flashes 3 mes. At cri cal level light output decreases by 25%.
The temperature. When it increases to +70°C the main LED flashes 5 mes. A er +75°C the light output decreases to
Main3 mode. At cri cal level >+80°C light output decreases to Firefly mode.
Lock-out func on.
Unscrew the tailcap to 1/4 for the protec on from accidental switching on.
Service and Warranty
Armytek provides free warranty repair for 10 years from the purchase.
Warranty doesn't cover damage caused by:
1. Improper usage.
2. Attempts to modify or repair the flashlight by nonqualified specialists.
3. Longtime application in chlorinated or polluted water, or other liquids (other than water).
4. High temperatures and chemicals' exposure (including the exposure of liquid from defected batteries).
5. Usage of low-quality batteries.
Armytek Optoelectronics Inc.
Web: www.armytek.com Email:
Address: 67 Vandervoort Dr, Richmond Hill, Ontario, L4E 0C7, Canada
Specifications are subject to change without notice.
