3
(Fig 5)
3.4. Hang Vidashield Unit
3.4.1
Raise the VidaShield unit/trim kit bracket assembly to the
mounting plate before attaching power connectors.
(Fig 5)
See
VidaShield Installation and Operating Manual for details.
3.4.2
Once the electrical wiring has been complete, pre-apply blue
threadlocker to the machine screws. Then raise the VidaShield unit/
Trim Kit Brackets to the mounting plate, ensuring the trim kit brackets
are located on the outside flanges of the mounting plate. Finally,
secure the trim kit brackets to the mounting plate with the machine
screws reference above.
(Fig 6)
NOTE:
The mounting plate has integrated receiving hardware for
convenience.
3.5. Prepare Axiom Trim for Installation
3.5.1
Locate the Axiom trim and splice plates. It will be required to
pre-assemble the Axiom trim on the ground to locate the splice plates
prior to installing on the VidaShield unit.
3.5.1.1
First, remove the screw and locking plate from one side of
the splice plates.
3.5.1.2
Next, on the Axiom trim, there are upper and lower
channels in which to insert the splice plates. Install two splice
plates on both sides of each short Trim using the included pre-
painted flat head screws by installing the screw through the face
side of the trim into the backside of the splice plate, being careful
to avoid scratching the pre-painted screws. Then bend the splice
to 90°.
(Fig 7)
(Fig 6)
(Fig 7)
