Page
8
MT04-001 AquariTherm Tap (Manual)
www.dartvalley.co.uk
Re
vi
si
on N
o. M
AQ
TI
N
16
07
13
01
Switch C, Selects lockout on or off. In the ON position each valve
can be opened 4 times in a 15-minute block. The after each 15
minute block, both valve counts are reset.
Purging Notes:
When a valve is operated, the purging timer for that valve is reset.
The timer is reset from the time that the timer starts, so the purge
frequency is as set minus the valve open time.
The frequency ( time between purges ):- 24Hrs
Step 7 :
Time settings and basic operation
Step 6 :
Option setup
Sentry21
Shower Control System
Installation & Operating Instructions
03
03
14
03
03
14
Armitage Shanks
|
Armitage
|
Near Rugeley
|
Staffordshire
|
WS15 4BT
|
England
|
+44 (0)870 122 8822
Customer Care He44 (0)844 5436170
|
Fax +44 (0)844 5436171
|
As seen in the drawing below, the control box is supplied with a
4-way DIP switch and 3 in-line ON/OFF switches.
The first 3 DIP switches sets the valve open time, once activated
by the corresponding sensor. The 4th DIP switch selects if the
valve can be closed before the run time is reached, by operating
the sensor again.
The numbers on the switches i.e. 1,2,3 & 4 simply identify the
switch number; actual time settings available are shown below.
There are also 3 in-line switches fitted to the right side of the DIP
switches.
Settings:
Switch A, when set to ON selects ‘tap mode’, when set
to OFF selects ‘shower mode’. The only difference
between the 2 modes is the available valve open time is longer
for the shower mode.
Switch B, Selects purging ON or OFF. When set to ON the valve
opens for the set open time automatically if it has not been
operated during the purge time. Each valve has independent
purge operation, but the settings relate to both. The purge
frequency is every 24 hours.
AB
C
ON
ON
ON
Time settings: ( First 3 DIP switches ).
Both the Tap mode and Shower mode have default time settings,
i.e. if all of the first 3 DIP switches were set to off default settings
would apply. The DIP switches add time to these default settings.
The default time for the shower mode is 30 seconds. The default
time for the Tap mode is 6 seconds. This time can then be
increased by using any combination of the DIP switches as shown,
time in brackets is for the Tap mode.
Switch 1 = Adds 30 Seconds ( Adds 2 Seconds )
Switch 2 = Adds 60 Seconds ( Adds 4 Seconds )
Switch 3 = Adds 60 Seconds ( Adds 8 Seconds )
Any combination of switches can be set to on i.e. in the up
position, the setting adds up so that the time range available is:-
Shower settings; 30 seconds ( default ) - 180 seconds or 3
minutes.
Tap settings; 6 seconds ( default ) – 20 seconds.
When all connections and settings are made and checked, replace
lid and secure. After installation and setting of external equipment,
ON
12
34
e.g. sensors, valves etc. the supply should be connected.
Wave-on / Wave-off settings
Switch 4 ON enables Wave-on / Wave-off operation which allows
the valves to be waved off before the set time has finished. If not
waved off manually the valves will close automatically at the set
time as usual.
Power up
When all connections and settings are made and checked, replace
the lid and secure.
After installation of external equipment, such as sensors and
valves etc, the supply should be connected.
Operation
When the control box is powered any connected valves will be
opened for 2 seconds, the valves will close and after a short
period normal operation will begin.
The time period between the valves opening and normal operation
will depend on the set time, therefore this could be up to 20
seconds.
When a sensor is operated the corresponding valve will open for
the set time, if DIP switch 4 has been set to on, the valve can be
closed before the set time by operating the sensor a second time.
Each off the two channels operates independently, but both use
the same settings.
Page
4
IMPORTANT :
Changes to settings can only take place when
power has been disconnected for at least 5 seconds.
IMPORTANT :
Changes to settings can only take place when
power has been disconnected for at least 5 seconds.
S331001
S331101
S331201
S331301
0870 122 8822
