2.
Offer tap tails into basin holes, ensuring seals are in place. HOT tap should be fitted on
left hand side of the basin (viewed from front).
3.
Hand tighten the back-nut from under the basin, ensure the tap spout is positioned
correctly, and then tighten the back-nut securely with a tap wrench (24mm A/F).
4.
Slip a compression nut & olive onto the Ø15mm supply pipe. Push the supply pipe into
the tail up to the shoulder. Slide the olive up to the tail & tighten the compression nut - use a
24mm A/F spanner.
5.
RESTORE SUPPLIES & CHECK ALL JOINTS FOR LEAKS
When the isolator screw slot is
parallel to the valve body, the valve
is open & permits water to flow.
To close the valve, rotate the
isolator screw 90°. The filter can be
checked & cleaned by unscrewing
the cap using a 22mm A/F spanner. Expect some water to escape. The isolating valve can be
closed to permit servicing of the taps, or to remove the product.
Tap operation
We recommend isolation valves with filters be fitted to each supply pipe to permit future
maintenance of the product. Quote spares code E960086NU.
Isolation valves should be installed in an easily accessible location.
1.
Before connection, flush water through pipe-
work to remove all debris etc. to prevent
damage to the valve mechanism.
THEN ENSURE WATER SUPPLIES HAVE BEEN
ISOLATED.
Isolation valves should be fitted to permit future maintenance of this product.
DO NOT
apply heat near this product. Heat generated by
soldering could damage plastic parts and seals.
To operate this product,
simply press the handle
downwards & then
release. Water will flow
for the pre-set time & then
the tap will self close.
This is a water saving product &
is supplied set with a short run
time. A run time of typically 12 to
16
seconds will suit most
applications. Run time is
dependent on water temperature
& pressure.
Isolating valves
- 3 -
Anti-splash cleaning
On a regular basis the outlet should be inspected & cleaned.
Unscrew and remove the outlet.
In areas where lime scale build-up is prevalent this should be avoided by regular cleaning. If it
should build up, it will have to be removed.
An inhibited proprietary scale solvent can be used such as a kettle de-scaling solvent but it is
important to follow the manufacturer’s guidelines.
