3
1
IMPORTANT PRE-INSTALLATION NOTES
Connection to an
interrupted power supply
intended to stop electrical consumption in an unused facil-
ity, may adversely affect this sensor product and is therefore not recommended.
Each time the power supply is reinstated the product briefly enters reprogramming mode.
During reprogramming mode, any interaction (passive or active) with the product may alter the sensor
settings in respect to range and / or run duration.
No significant savings will be achieved by connection to an interrupted supply. These products are in
-
trinsically economical in terms of both water and electrical energy and will shut down in the event of a
sensor being obstructed.
SENSOR PROTECTIVE COVER
This product is supplied with the sensor lens covered over with a black-out material.
DO NOT REMOVE
this lens cover until the product
installation has been completed & then wait for at least 20
seconds
after
powering-up.
The lens cover prevents the sensor from being unintentionally
reprogrammed during the powering up sequence.
MAINS ELECTRICAL POWER SUPPLY
Mains powered Sensor Operated Products must be connected to a (fused / switched)
continuous permanent power supply
.
Don´t
remove, read
instruction 1st
DURING SETTING UP PROCEDURE
AVOID HIGH VISIBILITY CLOTHING
NOTE: An alternative sensor cover is supplied,
but is intended to be used by cleaning staff.This
cover prevents
water flow from
being triggering
during cleaning.
This flexible plas
-
tic cover can be
snapped onto the
spout body over
the sensor. See
section 6.
