5
You can use one of the optional Risers for increase the height of illuminator’s mount (for example, when
a large objective lens interferes with or obscures the beam). In this case install the XLR-IR850 on the rail
of riser (E). Then install the illuminator with riser on the Weaver rail of NVD so that the recoil stop of riser
slides into one of the transverse slots of the rail. Tighten the nut (F) of riser using a screwdriver.
FigUre 3. MoUnting tHe Xlr-ir850 illUMinAtor to A nigHt Vision DeVice
A
B
E
C
F
D
bAtterY instAllAtion
Fully charge the 18650 rechargeable battery before installing in XLR-IR850 illuminator. Insert the bat-
tery into charger, aligning the polarity symbols on the battery with the polarity symbols on the charger.
Never install the battery backwards.
Connect the power cord to an appropriate power source. An indicator light will flash red when a bat-
tery is charging, and will change to green when battery has been fully charged. Remove the battery
promptly after charging has been completed.
cAUtion:
• Use only the supplied battery, and do not install any other types.
• Keep the lithium batteries well away from flames or extreme heat or combustible materials.
If handled or recharged incorrectly, lithium ion batteries can cause fires, explosions, property
damage, injuries, and death.
• Keep the batteries and charger well away from water or liquids of any kind. Exposure to water
may cause shock hazards and fatal electrocution.
• Do not leave lithium ion rechargeable batteries and chargers unattended while recharging.
• Do not operate the charger on wood, carpet, fabric, or any other soft or flammable surfaces.
• Do not attempt to recharge disposable lithium batteries. Do not use any unprotected lithium
ion rechargeable batteries. Never recharge lithium ion batteries in any chargers other than
those designed for the specific battery types being used.
Install the battery as follows (refer to Figure 4):
cAUtion:
Ensure that the IR Illuminator is off before installing the battery.
