www.
Armagard
.com
Page |
4
Toll Free (US):
1-866-434-0807
Call (UK):
0121-608-7210
Step 6: Connect the USB cable into your computer, and then the 20-pin internal connection
to the setup port (highlighted red) on the controller board (figure 2).
Figure 2
Warning: Do not touch the controller board if the Plastic cover has been removed and the
power is turned on.
Step 7: Power the enclosure back on.
Step 8: Once the board is connected to the computer through the setup cable, Windows will
automatically start looking for the drivers.
Step 9: Open the ‘ArmagardTerminal’ program from your computer (mentioned earlier) and
select the correct COM port from the drop down menu as shown in figure 3 box 1. The
correct COM port should be the last one on the list from the drop down menu.
Figure 3
Step 10: Set the default BAUD rate for setup as 19200. These can be selected from the pre-
set figures shown in figure 3 box 2 above. Now click ‘connect’, highlighted in figure 3 box 3
above.
20-pin
connector
