Pro871 and Pro871C Cable Locator
Operating instructions
WARNING – Read and understand the instructions before operating this
unit. Failure to do so could lead to injury or death.
The Armada Technologies Pro871 (the Pro871C adds the optional clamp) wire
and valve locator is designed to find underground cables and trace their paths.
The complete Pro871 kit consists of;
•
(1) Pro871R Receiving Wand
•
(1) Pro871T Transmitter and Carrying Case
•
(1) ProH1 Mono Headset
•
(1) ProGS Ground Stake
•
(1) Set of Black/Red Connecting Leads
•
(1) Operating Manual
•
(1) IC871 Inductive Clamp (Pro871C only)
Please be sure that all items are included before operating the Pro871.
Battery Installation
- The Pro871 transmitter requires 8 “D” cell batteries. The
Pro871 receiver requires one 9v battery. To install the batteries in the Pro871
transmitter, open the case and remove the 2 holding screws on the battery
compartment located on the right side of the unit. Place the batteries in the
holder, orienting them in accordance with positive and negative poles. Turn on
the Pro871T and make sure the green ON LED comes on. If no response is
seen, try adjusting the batteries to insure good connection. If still no response,
be sure the batteries are good and fresh.
The Pro871R receiver battery compartment is located on the backside of the
Pro871R unit. Open the battery compartment cover. Install the 9 volt battery
and replace the cover. Turn the unit on and observe the ON LED to confirm
good battery install.
