Copyright © 2015 ARM Ltd. All rights reserved.
Debug and Trace Configuration
MCB1700 – NXP LPC100
ULINK
pro
Debugger and Trace Adapter
In the dialog
Options for Target – Debug
enable
Use
and select
ULINK Pro Cortex Debugger
.
Click on
Settings
.
Switch to the
Pack
tab and check
Enable
to activate the Debug
Description.
Switch to the
Debug
tab and ensure that
Port
is set to
SW
for Serial Wire Debug.
You may adjust the
Max Clock
to the desired debug speed.
Trace Settings
For full trace capability, switch to the
Trace
tab, enter the correct CPU
Core Clock
speed as specified in your
project and check
Trace Enable
.
Set
Trace Port
to
Sync Trace Port with 4-bit Data
.
Set the clock delay time for data pins
CLK
to
4.9ns
. Leave the individual
delay times at zero.
Complete trace configuration instructions for this board can be found on the web page
www.keil.com/mdk5/ulink/ulinkpro
. Choose
ULINK
pro
User’s Guide
in the
Quick Links
and continue with
the chapter
Configure Cortex-M Devices for Tracing
. Select chapter
NXP LPC17xx Devices
and then
Enable 4-Pin Trace (ETM)
.
