DSTREAM-XT Getting Started Guide
Document ID: 102443_1.0_00_en
Version 1.0
Set up your DSTREAM-XT system
3 Set up your DSTREAM-XT system
This chapter contains instructions about connecting the DSTREAM-XT system to your host
computer and target system.
3.1 Install the USB drivers for the DSTREAM-XT system
on Windows
To use the DSTREAM-XT system with a USB connection, for your operating system, install the USB
device drivers provided with Arm
®
Development Studio 2021.1 or later.
Before you begin
Ensure you have:
• Installed Arm Development Studio. For more information, see the
• Administrative privileges on your host computer.
About this task
The drivers for the DSTREAM-XT system are optionally installed as part of the installation process
for Arm Development Studio. If you have skipped the driver install process in Arm Development
Studio, follow these steps to install them.
Procedure
1. Using administrative privileges, run the
driver_install.bat
batch file that is available in
<Arm_Development_Studio_install_directory>\sw\driver_files
directory.
2. In the
Arm Development Studio Driver Installation Wizard
, click
Next
and follow the steps.
During installation, you might receive warnings such as
Windows can't verify
the publisher of this driver software
. You can safely ignore these warnings and
continue with the installation.
3. After the drivers are installed, click
Finish
.
Results
The USB drivers are now installed on your host computer.
Related information
Connect and power up the DSTREAM-XT system
on page 26
Copyright © 2021 Arm Limited (or its affiliates). All rights reserved.
Non-Confidential
Page
25
of
38
