Control panel is shown below:
（
1
）
On/Off “
” button: a.
Press
“
”. The heater starts working. When the heater is
working, press “
” again, the heater stops working and turns into stand-by state.
(2)
“
”
button: Press this button for 3 seconds to enter into the programmed mode,
and shift the date by pressing the “PROG” button.
(3) Working mode button:
“ ”
: the temperature can be set between 5 and 35
℃.
“
”
: the temperature can be set between 5 and 25
℃.
“ ”
: the temperature can be set between 5 and 15
℃.
(3)
“ ”
、
“ ”
button:
a. Under the working mode, press this button, the temperature can be regulated from 5 to 35
degrees. Each press of the button, the temperature will be increased or decreased by 0.5 degrees. If
press the button over 3 seconds, the temperature will be increased or decreased by 0.5 degrees at a
speed of 0.3 seconds. Once the temperature is set, if there’s no other operation, the heater will
judge this setting as a definitive setting. (The factory’s preset temperature is 35 degrees, and the
new set temperature will be stored in the memory).
b. Under time set mode, press this button to set current time.
c. Under working mode state, Press this button to regulate the 3 working modes’ working
time respectively.
d. When the heater is working, press
“ ”
or
“ ”
button ,the screen will indicate the setting
temperature.
(4) Lock/ Unlock button
a. Under the locking state, press the button
“ ”
on the control panel or on the remote
control for 3 seconds and the heater will be unlocked.
b. If no button is pressed within 60 seconds, the button on the heater becomes locked on the
display “
”.
（
5
）
Instruction for LCD as below: