5
6
Introduction
The Wireless Door Chime (DC678) consists
of two separate units:-
1. Push Button Unit
(Transmitter) IP55 weather proof rated
2. Chime Unit
(Receiver)
These units are completely self-contained
and no wiring between them is necessary.
Range
Up to 100 metres.
NOTE: Range depends on location,
temperature, and battery condition.
Important Notes
1. The operation and range of your Wireless Door Chime depends on location,
temperature and battery condition.
2. Try different locations in your home, ideally more than 1 metre from the floor.
Move Chime unit closer to Push Button unit to improve operation.
3. Do not expose either unit to rain or immerse in water.
4. Avoid locations where the Push Button unit is exposed to direct summer sunlight.
5. Do not leave exhausted batteries in Push Button unit.
6. Clean only with a damp cloth and mild detergent. Do not use solvents.
7. In an event of power outage, surge or unstable main power supply, your door chime
will default to factory setting. Please reset the unit according to ‘Resetting the Unit’.
Security
When you are away from home for long periods you may wish to leave your Chime Unit
with one of your neighbours so that they can monitor callers to your house during
your absence.
Trouble Sooting & User Hints
Problem
Possible Cause
Suggested Remedy
Chime
does not
sound.
1. Units are out of range (max.
range 100m).
Operate the Chime unit within the
operation range (100m).
2. Push Button and Chime units
are not on same frequency
coding.
Re-set the frequency coding (see Code
Selection) or select a different tone (see
Tone Selection).
3. Flat Push Button battery.
Change the battery.
4. Wrong polarity of battery in
Push Button.
Re-insert battery with polarity to match
markings.
5. Power outage, surge or
unstable main power supply.
Re-set unit according to
‘Resetting the Unit’.
Chime
sounds
without
Push
Button
being
pressed
1. A power interruption to the
Door Chime unit plus a similar
door chime product operating
nearby has caused the chime
unit to reset to the incorrect
House Code
A. Switch off the Chime Unit for at least
1 minute. Switch on again. It should
beep twice. Press the Push Button to
operate the chime. This re-sets the
House Code in the Chime Unit or;
B. Re-set the frequency coding (see Code
Selection
2. A similar Wireless Door Chime
product is operating nearby on
the same House Code.
Re-set the House Code
(see Code Selection).
3. Interference from CBs, Taxis or
remote control toys operating
on the same frequency.
Re-set the House Code
(see Code Selection).
CPIN002726
Wireless Door Chime
with Gloss White Finish
DC678
Installation & Operating
Instructions
CPIN002726
Warranty
Arlec guarantees this product in accordance with the Australian Consumer Law.
Arlec also warrants to the original first purchaser of this product (“you”) from a retailer that
this product will be free of defects in materials and workmanship for a period of 12 months
from the date of purchase; provided the product is not used other than for the purpose, or in
a manner not within the scope of the recommendations and limitations, specified by Arlec,
is new and not damaged at the time of purchase, has not been subjected to abuse, misuse,
neglect or damage, has not been modified or repaired without the approval of Arlec and has
not been used for commercial purposes (“Warranty”).
If you wish to claim on the Warranty, you must, at your own expense, return the product, and
provide proof of original purchase and your name, address and telephone number, to Arlec at
the address below or the retailer from whom you originally purchased the product within 12
months from the date of purchase.
Arlec will (or authorise the retailer to) assess any claim you may make on the Warranty in the
above manner and if, in Arlec’s reasonable opinion, the Warranty applies, Arlec will at its own
option and expense (or authorise the retailer to) replace the product with the same or similar
product or repair the product and return it to you or refund the price you paid for the product.
Arlec will bear its own expenses of doing those things, and you must bear any other expenses
of claiming on the Warranty.
The Warranty is in addition to other rights and remedies you may have under a law in relation
to the product to which the Warranty relates.
Our goods come with guarantees that cannot be excluded under the Australian Consumer
Law. You are entitled to a replacement or refund for a major failure and for compensation for
any other reasonably foreseeable loss or damage. You are also entitled to have the goods
repaired or replaced if the goods fail to be of acceptable quality and the failure does not
amount to a major failure.
Arlec Australia Pty. Ltd. ACN 009 322 105 (“Arlec”) gives the Warranty.
Arlec’s telephone number, address and email address are:
Customer Service: (03) 9982 5111
New Zealand Toll Free: 0800 003 329
Building 3, 31 – 41 Joseph Street, Blackburn North, Victoria, 3130
Blackburn North LPO, P.O. Box 1065, Blackburn North, 3130
Email: [email protected]