Telescoping pole extends
upward from 17 inches to
29 inches.
Compatibility:
Fits smartphones with
cases weighing up to 2
pounds and measuring
up to 4” wide.
IMPORTANT:
Do not overtighten ring.
Overtightening may
damage threads on
holder and also make it
difficult to adjust phone
and tablet holders.
3
4
Attach mount to surface by tightening
C-clamp knob. Slide optional rubber clamp
boot onto the top of the mount’s clamp to
prevent scratching clamp surface if desired.
Attach overhead arm assembly to clamp
pedestal by unscrewing the collar at the top
of the pole until the metal ball side of the
overhead arm assembly fits into the collar.
Tighten collar clockwise to secure.
Your Remarkable Creators Bundle will arrive in seven pieces:
HD011-B
Clamp Pedestal
with Telescoping
Pole
SP25MMCAM
25mm to 1/4”-20
Camera Bolt Adapter
(optional)
2
RV001WR-B
For thicker tables or desks, adjust the clamp
bracket by using a Phillips screwdriver to
remove the screws from the top position and
move them to the bottom position.
Unscrew tightening ring from holder.
Place ring over the 17mm end of mount
then snap the holder onto the ball. Set to
desired position, then tighten ring.
Using two hands, insert phone into the
holder by pushing the device into one of the
spring-loaded support arms. Expand the other
support arm and fully insert device until it lays
flat against the blue rubber pad.
Assembled Mount
SP3RMPR0PL
Tightening Ring
Tightening
Knob
Collar
Metal
Ball side
Continued on page 2
CLAMPRCB
| Remarkable Creators Video Phone and Tablet Clamp with Ring Light
rev.092418
HD011-B
RV001WR-B
Phone Holder
SPLEDRING
LED Ring Light
SP3RMPROPL
Overhead Arm
Assembly
GN031-SBH-B
Clamp Post Mount
TAB001
GN031-SBH-B
5
Shafts can be adjusted by unscrewing
the shafts’ knobs to loosen. Tighten
knobs to set.
TAB001
Tablet Holder
Clamp Bracket
C-Clamp Knob
C-Clamp
Screws
Screws
1
a
1
b
