Arkbird FPV OSD V3.1028, Руководство пользователя

Страница: 14 / 21

Arkbird FPV
-14-
Set CTL Parameters
Roll Ctl Roll Control
（
%
）（
equivalent to travel range on radio, Please adjust the travel
range on OSD, do not adjust through radio
）
Pitch Ctl Pitch Control
（
%
）
Yaw Ctl Yaw Control
（
%
）
------------------------------------------------------------------------------------------------------------ ------------------------------------
Neutral Check Neutral Point Check:
Neutral point alignment needed under first installation, not used for weeks,
or temperature variation is more than 10 degrees.
Aileron all the way to the right means it is waiting autopilot be put down, OSD
shows “Waiting Neutral Point Check.”
Put the autopilot paralleled to the ground (Please prop up if there is a landing
gear), and move CH1 left and right to do 3-seconds neutral point check. Aileron
will be back to center once finished.
Note: Pushing CH5 and CH6 to minus (0%) and moving CH1 stick to left or right
side within 3 seconds after power on can also enter neutral point check.
Launch Assist
After turning the function on (ON), "Launch Assist" function which can help to control throttle and reduce
the difficulty of take-off in manual throwing process.
Switch to balance mode, and the throttle will not be started, OSD displays "T throttle’s volume" and
"Launch" tip (as is shown below), which means launch assist will occur.
Run up with aircraft in hands, when the speed is higher than 5kmph, the throttle will start output and
automatically control the take-off.
Note: This function can only be started when more than 6 GPS satellites are available. In order to ensure
safety, in run-up process, lower the throttle stick, lower the aircraft head down 35° or stop the run-up, throttle
will be disabled. When the aircraft flies above 15m high, or more than 100 m away, launch assist will be disabled
and throttle will under normal control.
----------------------------------------------------------------------------------------------------------------