15 min
Auralis
2s
1
Assemble seat cushion and pump
Start the Auralis system
2
When the pump is connected to a
power source it runs a self check:
Beep - 10 seconds - 2 beeps - ready
to use.
Press and hold Run/Standby button.
The following indicators are shown:
• Run/Standby
• Wait indicator
• Alternating mode button
• Comfort control indicator
• Battery charge indicator
• Green indicators on the front of
the pump
Once the Wait indicator turns off,
place bed sheet on mattress. Make
sure that the CPR rapid deflation
unit is clearly visible.
Place patient on the mattress or
seat cushion.
Alternating mode is set by default.
Assemble mattress overlay or mattress replacement and pump
CPR unit is clicked into
closed position.
“Click”
3
Connect the tubeset.
Zip the protective cover
over the mattress. Arjo
logo visible at the foot
end.
Auralis
2
Mattress overlay:
Place on top of base mattress.
Secure with 4 fixing straps.
Mattress replacement:
Place on bed base.
Attach the 8 securing straps to
moving parts of bed frame.
• tubeset at foot end
• CPR at head end
• cells facing up
1
4
5
6
Hang the pump at the
foot end of the bed.
Place cable in the cable
management. Close the
flap around the cable with
the press studs.
Connect power cable to
power source.
“Click”
Seat cushion:
Place on chair surface.
Use the fixing straps to attach.
Place pump on floor, cable under chair,
tubeset placed alongside chair.
Connect the tubeset.
Connect power cable to power source.
2
1
• cells facing up
• tubeset at front right corner
• cells horizontal across chair,
V-shape towards front
Front of chair
Back of chair
“Click”
08.AI.02EN_01 • 06/2020 • Page 1/2
QUICK REFERENCE GUIDE - USE
Auralis