Ariston UP 300 X EU, Инструкция по установке и эксплуатации

Страница: 13 / 84

11
GB
A
Button for turning the appliance ON or OFF.
Press the button once and hold in for at least
two seconds.
B
Button to turn off the acoustic alarm.
Press the button once and hold in for at least
two seconds
C
Warning Light
When this red indicator light turns on and the
buzzer sounds, the freezer is not operating correctly
and the temperature is rising too much.
If only the buzzer sounds (with the indicator light
turned off), then the freezer door has been left open
for over 60 seconds.
D
Green Temperature Lights
These indicator lights show the storage temperature
selected (between -16°C and -24°C)
E
Yellow Fast Freeze Light
This light comes on when the " SUPER " setting has
been selected, which is used to fast freeze fresh
foods.
It turns off automatically after 48 hours when the
appliance has finished the
SUPER function.
F
Thermostat and SUPER Button
This button is used to set the storage and freezing
temperature. Pressing the button once and holding
it in for at least two second activates the blinking
LED indicating the thermostat and
SUPER settings.
Each time the button is pressed again for two
seconds (within a span of 5 seconds) a new tem-
perature setting is selected (-24, -21, -18, -16 °C).
The
SUPER setting is automatically deactivated
after 48 hours, and the appliance returns to previ-
ous temperature setting.
G
Storage Compartments
H
Compartments for Freezing and Storage
NOTICE
After transport stand the appliance upright and wait
at least 3 hours before plugging the appliance into the
mains to ensure proper performance.
For the best and most cost effective performance, re-
member to set the temperature at -18°C.
Once the appliance has been connetect to the electrical
mains, press the
A button (ON-OFF) and hold it pressed in
for more than 2 seconds in order to turn on the appliance.
Activate the SUPER setting using the F button. Each time
the button is pressed for more than two seconds it enables
and displays (with a blinking LED) the temperature setting.
Each time the button is pressed within 5 seconds, the set-
ting advances through the cycle of possible settings. Set
the appliance so that
E LED begins to blink and remains
lighted.
The appliance automatically exits the
SUPER mode after 48
hours, returning to the temperature set.
If the lights blink and the alarm sounds after the appliance is
connected to the power supply, press the
B button (alarm
off button) for at least two seconds.
Setting Up Your Appliance