5
Installation
Mounting to a stud is recommended. However, if fitted to other wall linings (plasterboard, concrete etc) suitable
fixings will be required. Before drilling any holes check that the wall and ceiling are clear of any electrical cables,
pipes etc.
1.
Pre drill pilot holes in the positions given (pg 4 - Installation position). Fix the fixing plate using the screws
supplied or appropriate wall fixings, check with a spirit level to ensure bracket is level. Tighten screws.
2.
Mark the position of the decorative chimney at the ceiling and wall. Cut the cornice moulding away if
required, to enable the chimney to sit flush against the wall and ceiling.
3.
Only if ducting
- Mark and cut out the hole in the ceiling / wall to fit the ducting (160mm dia max).
Warning: Chimney depth is 172mm. Ensure no part of the hole is greater than 170mm from the wall.
4.
Use the upper chimney bracket as a template to mark the fixing screw positions. Using the screws
supplied, fix the chimney bracket to the wall, checking that it is central about the canopy.
Wall stud
Fixing screw
Rear wall
Fixing plate