Ariston AWD 121 NA, Руководство по обслуживанию

Страница: 17 / 24

mod.AWD121NA page 17
5. Replace pressure sensor
6. Replace the board
F16: Non-functioning basket block
1. Go over connector card CNC
2. Go over connector basket block
3. Control Continuity of cabling CNC / basket block and basket block supply
4. Replace basket block
5. Replace card
N.B.From Fault F01 to fault F11
These are shown by LEDs in stand by/on in LVB2000 machines Ariston/Indesit.
From fault F01 to fault F12
These are shown in a display located on the instrument panel of LVB2000 ma-chines
Evolution Indesit.
From fault F01 to fault F15
Are those that are indicated according to the version via LED stand by/on or
display positioned on the Wash Dry machine Ariston/Indesit panel.
4. Replacing the card
Should you have to replace the card:
· retrieve the EEPROM from the old card
· reassemble the EEPROM onto the new replacement card (without EEPROM)
In the event, and only in this case:
· an F02 has been detected
· the above-mentioned checks have been carried out and no problems have been detected on the wiring or to the motor
· the card fitted onto the washing machine is a 12 or 20 version (the version is indicated by a label on the module-containing box
with SW20 or SW12)
you should:
· fit on a new card (version 32 or above)
· fit on an updated EEPROM to request from the assistance service centre, stating the code (e.g. 80xxxxx0000 or 46xxxxx0000),
the serial number and the washing machine model.
n1040242: Power card with welded eeprom.
-----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
From serial number 20304.0001, IDC power card with welded eeprom is used to ensure the perfect connection of all parts, in the
Comunanza, Teverola and Brembate factories.
To replace the module with welded eeprom, it will be necessary to use the eeprom indicated in the SAT document of the model
concerned.
To replace the module on a unit with welded eeprom both the SAT module and the eeprom are required, because the latter cannot
be reused.