The first wash cycle
Once the appliance has been installed and before you
use it for the first time, run a wash cycle without
detergent and no laundry, setting the 90˚C programme
without a pre-wash cycle.
Models
A1637
A1437
A1237
59.5cm wide
Dimensions
85cm high
60cm deep
Capacity
from 1 to 7kg Wash
Electric
voltage 220/240 Volts 50Hz
connections
maximum absorbed power:
1700W-2100W
Water
maximum pressure 1 MPa (10 bar)
connections
minimum pressure 0.05 MPa (0.5 bar)
drum capacity 54 litres
Spin Speed
up to 1600 rpm - A1637
up to 1400 rpm - A1437
up to 1200 rpm - A1237
Control
programme 3
programmes
temperature 60˚C
according to -
run with a 7kg load
IEC456
directive
This appliance is compliant with the
following European Community
Directives:
- 73/23/EEC & 93/68/EEC
(Low Voltage) and subsequent amendments.
- 89/336/EEC,92/31/EEC & 93/68/EEC
(Electromagnetic Compatibility) and subsequent
amendments.
Drainage connections
A. Connect the drain hose,
without kinking it, to a
draining duct or a wall
drain fixed at a height
between 65 and 100cm
from the floor.
B. Alternatively, place it
over the edge of a basin,
sink or tub, fastening the
hose supplied to the tap.
The free end of the hose
should not be under
water.
!
We advise against the use of hose extensions. In
case of absolute need, the extension must have the
same diameter as the original hose and must not
exceed 150cm in length.
Electrical connections
Before plugging the appliance into the mains socket,
make sure that:
●
The socket is earthed and in compliance with the
applicable law.
●
The socket is able to sustain the appliances
maximum power load indicated in the Technical
Details table (
on the right
).
●
The supply voltage is included within the values
indicated in the Technical Details table (
on the right
).
●
The socket is compatible with the machines plug.
If this is not the case, replace the socket or the
plug.
!
The machine should not be installed in an outdoor
environment, not even when the area is sheltered,
because it may be very dangerous to leave it exposed
to rain and thunderstorms.
!
When the machine is installed, the mains socket
must be within easy reach and should be connected
to a suitable electrical supply.
!
Do not use extensions or multiple sockets.
!
The power supply cable must never be bent or
dangerously compressed.
!
The power supply cable must only be replaced by
an authorised serviceman.
!
The company denies all liability if and when these
norms are not respected.
3
Technical Details
Installation
A
B
GB