Ariston A1235, Инструкция по использованию, уходу и установке

Страница: 13 / 16

Troubleshooting
11
Problem:
The washing machine won’t
start?
The wash cycle won’t start?
The washing machine fails
to fill with water?
The washing machine
continuously fills with water
and drains?
The washing machine does
not drain or spin?
The washing machine
vibrates too much during the
spin cycle?
The washing machine leaks?
The ON-OFF/DOOR LOCKED
LED flashes rapidly at the
same time as at least one
other LED?
There is too much foam?
Possible causes / Solution:
●
The appliance is not fully plugged into the socket.
●
There has been a power failure.
●
The appliance door is not shut properly.
●
The button has not been pressed, for at least 2 seconds.
●
The START/RESET button has not been pressed, for at least 2
seconds.
●
The water tap is not turned on.
●
A delayed start has been set (using the Delay Timer, see page 7).
●
The water inlet hose is not connected to the tap.
●
The hose is kinked.
●
The water tap is not turned on.
●
There is a water shortage.
●
The water pressure is insufficient.
●
The START/RESET button has not been pressed, for at least 2
seconds.
●
The drain hose is not fitted between 65 and 100cm from the floor (see
page 3).
●
The free end of the hose is underwater (see page 3).
●
The wall drainage system doesn’t have a breather pipe.
If the problem persists even after these checks, turn off the water tap,
switch the appliance off and call for assistance. If the dwelling is on one
of the upper floors of a building, there may be drain trap problems
causing the washing machine to load and unload water continuously. In
order to avoid such an inconvenience, special anti-drain trap valves are
available in shops.
●
If the machine was unable to balance the load it will use a slow spin
rather than risk machine damage; the clothes might appear wetter
than expected.
●
The Easy Iron option is enabled: to complete the programme, press
the START/RESET button (see page 7).
●
The drain hose is bent (see page 3).
●
The drain duct is clogged.
●
The transit bolts were not removed correctly (see page 2).
●
The washing machine is not level (see page 2).
●
The washing machine is closed in, between furniture cabinets and the
wall (see page 2).
●
The water inlet hose is not screwed on correctly (see page 2).
●
The detergent dispenser is obstructed (to clean it, see page 10).
●
The drain hose is not secured properly (see page 3).
●
Call for assistance because this means there is an error.
●
The detergent is not suitable for machine washing (it should bear the
definition “for washing machines” or “hand and machine wash”, etc.)
●
You used too much detergent.
Your washing machine could fail to work. Before calling for assistance (see page 12),
make sure the problem can’t easily be solved by consulting the following list: