3G/GSM Gate Opener 8/18
Rev. V1.4B, Jan 2019
7. OPERATION
Programming of authorized telephone numbers in the unit will enable these numbers to call the gate
opener’s Mobile number, and whenever the unit
receives a call, it will recognize the authorized
telephone number(s) calling it, and will disconnect without answering (so there will be no charge).
The gate or door relay will be activated. The relay can also be temporarily or permanently switched
on or off by sending SMS or dialing in.
This 3G/GSM Opener can enable users to gain access from their mobile phone by two methods
1. Caller ID recognition
2. by access control password mode
1. Caller ID recognition to open
Ring in to open the door for an authorized telephone number.
2. Access control password to open
Dial the SIM card telephone number. The unit will answer the call and you will hear a bleep tone.
The door can be opened after enter correct password code. Or just simply send SMS password code
to the device.
*71*5678#
：
Trigger relay 1
*72*5678#
：
Hold relay 1
*73*5678#
：
Release relay 1
*74*5678#
：
Trigger relay 2
*75*5678#
：
Hold relay 2
*76*5678#
：
Release relay 2
*This is for door open option when telephone numbers are not stored.
8.PROGRAMMING
Programming can be carried out either by text message or by dialing into the GSM Gate Opener.
8.1 Programming by dialing in
Dial the SIM card telephone number. The unit will answer the call and you will hear a bleep tone.
Enter Programming Mode by Pressing…..
*12*
1234
# (1234 is default password)
A successful pass code will produce a single long beep. A failed attempt will produce 3 short bleeps.
Example: start to program the phone number for dialing in to open the door.
Use the following commands to program the unit
* Insert international country code (1~3 digits):
71[country code] #
* Add a number (up to 100 numbers):
72[relay][phone number] #
* Delete a number:
73[phone number] #
