Arista 7000 Series, Быстрый старт

Страница: 20 / 54

To remove the mounting bracket from the chassis, lift the front edge of the mounting bracket clip
with a flathead screwdriver and slide the bracket away from the front flange (opposite from the
installation direction).
Figure 12: Attaching the Mounting Brackets to the Switch Chassis
1 Bracket Clip
2 Bracket Clip
3.2.3 Expanding the Rails
The rail is a two-piece mechanism. The rail length is adjusted by sliding the rail-rod inside the rail-slide.
The rail clip prevent extension of the rail beyond the maximum supported distance between front and
rear rack posts. When the rail is contracted, the rail clip is closest to the slide end.
The rail is initially contracted and must be expanded to attach onto the rack. This procedure expands
the rails from their contracted state:
1. Grip the slide end with your left hand and the rod end with your right hand ( Expanding the Rails-
Left ).
2. Pull the ends apart until the rail-clip makes an audible click ( Expanding the Rails-Right ).
Figure 13: Expanding the Rails
1 Rail-slide end (grip with left hand) 3 Rail-rod end (grip with right hand) 5 Inset A (detail)
16