PAGE 5 • P3067-INS-R
B
•
877.287.8634
• NEED ASSISTANCE?
•
ARIESAUTOMOTIVE.COM
(Fig 15) Driver side-back of “tall” STD air dam
Hold air dam up against bottom of
Brackets (dashed line for reference).
Mark location of Bracket onto top of
air dam (arrows)
Do not cut through the top or bottom
edges of the “tall” air dam. Only remove
enough material to clear the Brackets
3/4” down
2-1/2”
3/4” wide slot
(Fig 16) Driver side-back of “tall” STD air
dam illustrated. All measurements are for
reference and example only, check all
measurements before cutting air dam.
3/4” down
(4) 12mm x 35mm Hex Bolts
(8) 12mm Flat Washers
(4) 12mm Lock Washers
(4) 12mm Hex Nuts
Front
Fig 14
(Fig 11) LED installed on support flange
(Fig 12) Insert an 8mm clip nut over the end of
the support flange and insert an 8mm hex bolt
(Fig 13) Slide the hex bolt into the light bar
cage and tighten
3/4” wide slot
(Fig 17) Driver side-back of “short” air
dam illustrated. All measurements are for
reference and example only, check all
measurements before cutting air dam.
