EN - 12
Position Drift Cutters
Use drift cutters if snow to be cleared is
higher than auger housing.
1. Loosen upper wing knob and remove
lower knob.
2. Rotate drift cutter and push cutter up as
shown in Figure 13.
3. Reinstall lower wing knob in desired
position and tighten upper knob.
4. Repeat on other side.
Clear a Clogged Discharge Chute
1. Stop engine, remove key and wait for all
moving parts to stop and for hot parts to
cool.
2. Use the snow clean-out tool to clear the
clog.
3. Return the tool to its storage position on
the auger housing.
STOP THE ENGINE
1. Release traction drive clutch lever.
2. Run auger / impeller for a few minutes to
remove loose or melting snow to prevent
impeller from freezing.
3. Release attachment clutch lever.
4. Stop engine and remove key from unit.
5. Turn fuel valve to off position.
TRANSPORT UNIT
1. Stop engine, remove key and close fuel
valve.
2. Secure unit chassis to transport vehicle.
NOTICE:
NEVER secure from rods or
linkages that could be damaged.
Your Ariens dealer can provide service and
adjustments to keep your unit operating at
peak efficiency. Contact an authorized engine
manufacturer’s service center for engine
service.
SERVICE POSITION
WARNING:
NEVER use your
hand to clean out discharge
chute.
Figure 13
MAINTENANCE
WARNING:
Read and
understand the
Safety
section
before proceeding.
WARNING:
AVOID INJURY.
Before tipping unit, close fuel
valve and drain fuel from tank
and fuel system. (Refer to
engine manual for instructions.)
Make sure unit is secure and will
not tip.
Figure 14
