Ariens Gravely 815045, Руководство оператора

Страница: 21 / 28

EN - 19
AIRFLOW INDICATOR
See Figure 35.
When the airflow indicator is pointed straight
up, the air is restricted which indicates one or
more possible problems:
• The mesh bags are full and need to be
emptied. See Emptying Mesh Bags on
page 19.
• There is a clog in the bagger. See Unclog
Bagger on page 19.
When the airflow indicator is facing forward,
the air is unrestricted indicating that the mesh
bags are not full and there are no clogs in the
bagger.
EMPTYING MESH BAGS
If bagger stops picking up grass clippings, the
mesh bags are likely full.
To empty mesh bags:
1. Disengage PTO, stop engine and remove
ignition key. Wait for all moving parts to
stop before leaving operator’s position.
2. Disconnect rubber latch and open hood.
3. Remove each mesh bag from hood
assembly.
4. Empty the grass from each mesh bag.
5. Install mesh bag on hood assembly with
the heat-resistant smooth surface of the
bags facing the engine.
6. Close and latch hood assembly.
UNCLOG BAGGER
If hose or blower assembly becomes
clogged, stop forward motion and allow unit
to clear itself. If unit will not clear itself, unclog
the hose and/or blower assembly manually:
1. Stop engine and remove ignition key.
Wait for all moving parts to stop.
2. Open the latch retaining hose to bagger
inlet and disconnect hose.
3. Remove hose from blower assembly.
4. Remove grass from clogged area.
5. Reinstall hose.
NOTE: Perform steps 6 and 7 if clog is in
blower assembly.
WARNING: NEVER open
hood assembly while the
engine is running and the PTO
is engaged.
ALWAYS shut off engine
before emptying mesh bags.
Figure 35
Airflow
Indicator
Airflow
Restricted Airflow
Unrestricted
CAUTION: MAKE SURE the
heat-resistant smooth surface
of the mesh bags are facing
the engine.
WARNING: MOVING PARTS
can cut or amputate body
parts.
NEVER attempt to clear
blower assembly while engine
is running.
ALWAYS stop engine, remove
key, and wait for moving parts
to stop.Sharp edges can cut.
Movement of parts can cut off
fingers or a hand. Wrap
blade(s), wear sturdy gloves
and use extreme caution when
working near blades or
impeller.
WARNING: PINCH POINT!
Use extreme caution when
unclogging blower assembly.
Impeller can cut or pinch your
hand, even when not in
operation. Wear sturdy gloves
when working near impeller.