20
Ariens
®
Riding Mower
11/99
C
LEANING
AND
S
TORAGE
IMPORTANT:
NEVER spray unit with water or store unit
outdoors to aid in prevention of rust or corrosion. Water
can seep into sealed bearings, which are sealed against
dirt and debris only, causing reduced component life.
Keep all nuts, bolts and screws tight and know unit is in
safe working condition. Check all hardware at regular
intervals.
Inspection
Inspect unit for visible signs of wear, breakage or
damage. Order any parts required and make necessary
repairs to avoid delays when beginning use again.
Grass Bag
Remove Grass Bag and clean out all debris prior to
storage. Grass Bag may be stored in position on mower.
Keep Grass Bag dry during storage.
Battery
Fully charge battery and store in a cool dry location.
Engine
When storing mower for an extended period, refer to
engine instruction for proper engine storage procedures.
Cleaning
Clean unit thoroughly. Touch up all areas to prevent rust.
Matching touch up paint is available from your Ariens
Dealer. Store mower in a cool, dry protected location.
T
ROUBLE
S
HOOTING
Problem
Probable Cause
Starter will not operate
when the ignition key is
turned to the "S"
position
Shift lever in gear (no spark).
PTO engaged.
Defective solenoid switch.
Blown Fuse.
Discharged battery.
Loose battery cables.
Defective starter.
Faulty interlock switch.
Solenoid switch clicks
but starter will not
operate when the
ignition is turned to the
“S” position.
Discharged battery.
Defective starter.
Loose battery cable.
Engine starter operates
but engine will not start
when the ignition switch
is turned to the “S”
position.
Fuel tank empty.
Fuel shut-off valve at the fuel tank
turned off.
Engine failure - See Engine Manual.
Shift lever in gear (no spark).
PTO engaged (no spark).
Engine starts but runs
roughly.
Engine choke in “ON” position.
Restricted air cleaner element.
Restricted fuel cap vent.
Engine carburetor malfunction - See
Engine Manual.
Engine electrical system trouble - See
Engine Manual.
Engine stops when PTO
or Fwd-Rev is engaged.
Operator presence seat switch not
pressed.
Faulty seat switch.
Wiring to PTO switch incorrect.
The tractor will not move
when the direction
control lever or pedal is
moved to “FORWARD” or
“REVERSE” position.
Gear shift lever in “NEUTRAL” position.
Fwd-Rev clutch needs adjustment.
Transmission disconnect is in the
disengaged position.
Attachment will not
operate.
PTO belt is off.