EN – 19
7.
Reinstall bearing flange and secure with three tapping
screws.
8.
Reinstall spring clip into hex shaft.
9.
Reinstall adjustment pivot pin onto speed selector arm
and secure with hairpin.
10. Reinstall bottom cover and secure with six hex bolts.
11. For wheel models, align wheel keyways with axle keys
and reinstall wheels. Secure with snap clips.
12. Return unit to operating position.
13. Reconnect spark plug wire.
14. Adjust speed selector lever. Refer to Operator’s
Manual for adjustment procedure.
IMPORTANT:
Check all adjustments after first use.
AUGER REPLACEMENT
Remove Auger
NOTICE:
Save all hardware for reinstallation.
1.
Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2.
Disconnect spark plug wire from engine.
3.
Separate auger housing from frame. See
Separate
Auger Housing From Frame
on page 10.
See Figure 31.
4.
Hold attachment drive pulley in place and remove
hardware securing pulley assembly to impeller shaft.
5.
Remove spacer bushing from impeller shaft.
6.
Loosen, but DO NOT remove hardware securing
bearing plate to auger housing.
Figure 30
1. Hex Shaft
2. Sprocket
1
2
CAUTION:
AVOID INJURY. Attachment drive
pulley edges are sharp. Wear gloves when
handling pulley.
Figure 31
1. Hex Bolt
2. Locking Washer
3. Attachment Drive Pulley Assembly
4. Bearing Plate
5. Spacer Bushing
1
3
4
5
2
