GB - 10
Tools Required
•
Adjustable wrench
•
9/16" wrench
•
Petroleum jelly or dielectric grease.
Unpack Unit
Remove unit and all other components from
the shipping container. Engage transmission
bypass lever (see
MOVING UNIT
MANUALLY
on page 16). Push unit from
container onto a level surface. Disengage
transmission bypass lever.
Connect Battery
See
Battery Removal and Installation
on
page 21 and perform steps 2 and 3 in the
installation section.
Place Unit in Operating Position
(Figure 3)
NOTE:
The seat is shipped with the seat
positioned as far back as possible.
1. Push steering levers aside and tip seat
up.
2. Adjust the seat as needed (see
Adjusting Seat
on page 15).
3. Remove hardware from top hole of the
steering lever (Figure 3). Slide steering
lever back to align slot with hole at the
top of the steering pivot arm.
NOTE:
Do not tighten hardware before
reviewing
ADJUSTING STEERING LEVERS
on page 23. If no adjustment is desired
tighten hardware.
4. Adjust steering levers (see
ADJUSTING
STEERING LEVERS
on page 23).
Place Discharge Chute in Operating
Position
Prior to operating the unit, remove the
discharge chute from the transport position
and place the discharge chute in the
operating position (figure 4).
ASSEMBLY
WARNING:
AVOID INJURY. Read
and understand the entire
Safety
section before proceeding.
WARNING:
Do not operate
mower unless the discharge chute
is in the operating position.
1. Steering Lever
2. Steering Pivot
Arm
3. Steering Lever
Hardware
Figure 3
1
3
2
