5
Technical Parameters
Technical
Parameters
Rated Voltage
AC110-120V 60Hz
Rated Current
10.2A
Normal Rated Power
1125W
Recommended Power Service
GFCI-Protected 20A
Water Pipe Dimension
½"
Drainage Pipe Dimension
1 1/2" (40mm)
Max. Hot Water Temperature
176°F (80°C)
Recommended Hot Water
149°F (65°C)
Operating Pressure
Max 116 PSI (8 bar / 0.8 mPa)
Recommended Operating Pressure
14.5-72.5 PSI (1-5 bar / 0.1-0.5mPa)
16
EN12764 2004 A1
:
+
AC110
-
120V 60H
z
9a
1100W
14
"L" = Live = Black or Brown
"N" = Neutral = White or Blue
“G"= Earth-Ground = Green or Yellow
22. Ensure the water supply lines for this product has its own dedicated water
shutoff valves installed in an accessible location.
23. Ensure there is enough space and access to connect, adjust or fasten the
various supply lines, waste line and other components.
24. Be sure to check each installation step with this manual to ensure the prod-
uct is installed correctly. The product must be installed with all the feet or sup-
portive legs touching the floor before any use. Leveling the product is an impor-
tant procedure and must be completed on-site – on the installation surface and
final installation position.
25. Always double-check all connections to ensure for proper installation, ten-
sion, and connection, including parts, plugs, hoses, nuts, screws, wires, etc.
26. Only a professional electrician is recommended to work on the high voltage
portions of installation and testing.
27. Electrical service must meet the requirements listed on the components of
the product, listed within this manual, or otherwise advised based on a thorough
analysis of any special circumstances.
28. An electrical protection device for short-circuits, power overloads or incor-
rect voltage must be installed and used in conjunction with this product.
29. This product or any appliance used near this product must be used in con-
junction with a Ground Fault Circuit Interrupter (“G.F.C.I.” or “G.F.I.”) or Resid-
ual Current Device (“R.C.D.”) with a trip current of not greater than 30mAor oth-
erwise required in accordance to local codes.
30. Do not cut or extend electrical wires or power-cord of the product without
the approval of a professional electrician and warranty service representative.
31. Appliances or components with ground or “earth” connections must be in-
stalled and used in conjunction with the product, and connected in accordance
to local codes.
32. The motor must be grounded with wire not less than 14awg (1.63mm-diam-
eter) or otherwise required in accordance to local codes.
33. Check local and national requirements before installing or purchasing this
product.
34. Local standards and codes must be followed and cannot be the responsibil-
ity of the supplier or its distributors.
35. Other electrical components, except the remote control device (optional),
should be kept, located or affixed away from the product, so they cannot fall
into the bath, while in use.
36. Do not disassemble the control panel or computer controller as it is not de-
signed for disassembly. Defects, damages or shock caused by such removal
cannot be the responsibility of the supplier or its distributors.
37. “H” hot (red) and “C” cold (blue) water supply connections and their orienta-
tion are critical to proper function of this product.
38. Ensure the (optional) “H” hot (red) and “C” cold (blue) water hoses will not
touch the floor when this product is fully installed, as it may cause rusting and
possibly weakening of those hoses.
39. Harsh chemicals such as acetone, ammonia or gasoline can possibly dis-
solve or damage portions of this product – do not use such chemicals for clean-
ing or installing this product.
40. Do not stack anything on top of this product, use it for support, or apply any
extreme pressure to critical areas that may cause misalignment or damage;
take special care when moving this product.
Test standard:
EN 12764: 2004+A1: 2008
EN 60335-2-60 (Low Voltage Directive 73/23/EEC)
EN 1111
