QBV100 8
ENGLISH
Installation (continued)
PREPARING THE NEW FAN
WARNING:
It is recommended that you wear safety gloves
when handling the ventilation fan because it has sharp edges
that could cause injury .
- Unplug the motor from the receptacle. See figure 6.
-
Remove the three screws securing the motor mounting
assembly to the fan housing and take the assembly out . See
figure 7.
-
Unscrew the screw securing the electrical wiring junction
cover and slide the cover upwards to remove it. See figure 8.
CONNECTING THE ELECTRICAL WIRING
WIRING CONNECTION REQUIREMENTS
OBSERVE ALL GOVERNING CODES AND ORDINANCES
1 . Electrical grounding is required for this ventilation fan . Check
with qualified electrician if you are not sure whether the
ventilation fan is properly grounded .
2 .
Failure to follow electrical requirements may result in a fire.
3 . A fuse in the neutral or grounding circuit could result in
electrical shock .
4 . If the hot/cold water pipe is interrupted by plastic nonmetallic
gaskets or other materials, DO NOT use for grounding .
5 . DO NOT GROUND TO A GAS PIPE .
6 . Save installation instructions for electrical inspector’s use .
7 . If codes permit and a separate ground wire is used, it is
recommended that a qualified electrician determine if the
ground path is adequate .
8 . DO NOT use an extension cord or adapter plug with this
appliance .
9 . The ventilation fan must be connected with copper wire only .
10 . The ventilation fan should be connected directly to the switch
through flexible, armoured or nonmetallic sheathed copper
cable . Allow some slack in the cable so the appliance can be
moved if servicing is ever necessary .
Electrical Wiring
Junction Cover
Fig . 6
Fig . 7
Fig . 8
