PiCUS TreeQinetic Manual
31
5.6 Tab
– Measure
5.6.1 Page
– Control
This page is used to control the data recording of a measurement.
If you start a measurement, the app
automatically displays this page.
First the measurement is initialized by
automatically performing the zero calibration
of all sensor modules. During this process
a timer counts down the seconds until the
measurement data recording starts. During
and after this calibration the instruments
should not be touched anymore!
Afterwards the measurement runs in live mode, i.e. data recording is paused.
This can be recognized by the red status lines at the top, whose displays do not change, and
the top of the 3 buttons, which shows the classic recording symbol (left picture).
The display and controls are:
1. Display of the time how long data has been recorded (is updated live in recording
mode).
2. Display of the number of measuring points already recorded (is updated live in
recording mode).
1.
2
.
3.
4.
5.
