Battery installation
This camera uses 4 AAA alkaline batteries. (Do not mix batteries of different
types.)
1.
When replacing batteries, make sure the camera is turned off.
2.
Turn the camera upside down and slide the battery door toward the side of
the camera to unlatch then swing it open.
3.
Install the batteries according to the polarity diagram on the inside panel of
the battery compartment door.
4.
Close the battery door and slide it inward to lock in place.
WARNING: Removing the batteries will erase the camera’s memory—any
pictures left in the camera will be deleted.
Power (sleep-mode on/off button)
Pressing the button marked POWER located on the top of the camera will
either wake up the camera or put it into sleep mode. The camera
automatically defaults to sleep mode approx. 30 seconds after non-use.
(When in sleep mode, the LCD has no display.)
NOTE: To completely devoid the camera of power, and to preserve battery life,
remove the batteries.
Installing the CF card
This camera accepts only CF type I cards.
1.
Make sure the camera is turned off.
2.
Open the card-slot door located on the bottom of the camera.
3.
Gently slide the CF card into the card slot terminal-end first with front of
card facing front of camera. (CF card sold separately.)
4.
Close card slot door.
5.
To remove the CF card, open the card slot door and push the release
button located beside the card slot.
NOTE:
•
For best operation, use only high-quality CF cards such as SanDisc™ or
Kodak™.
•
When installed, the Argus DC2250 saves captured images and movies
directly to the CF card and bypasses its internal 6MB SDRAM memory.
•
Changing the batteries will not erase the CF card memory.
6