Assembly Instructions
10
Step
15
Step
16
Fit the top
Lower the top onto
the assembly.
Note:
The top must be
flush with the back edge
of the left and right end.
Use a screwdriver to
tighten the 4 large
locking nuts fitted to
the left end and right
end .
Lay the unit back
down onto its front.
C
3
1
2
3
1
2
y
y
x
x
b:
Fit the back
a:
Square up the unit by
making sure that
measurement
x to x
equals y to y.
b:
Place the back
onto the unit.
Nail around the
outside edges of the
back .
Note:
Nails should be
spaced about 150mm
apart.
Stand the unit up for
the next step.
13
J
The measurement from top corner X to bottom corner X must be
equal to the measurement from top corner Y to bottom corner Y
a:
13
J
Note:
To make it easier to fit
the top, place polystyrene
blocks from the packaging
underneath the end panels to
raise the assembly.
Polystyrene
block
Polystyrene
block
13
Note:
The back
edge of the top
must be flush with
the end panels
