Assembly: Only for OSB Floor
Step 1
Identify the 2 long beams
and 2 shorter beams.
On a level surface create
the required layout, as
shown. Secure the shorter
beams in place using 2x
100mm screws as shown in
the diagram.
Step 2
the top of the frame and
measure out where the
beams meet the frame.
Once all markings have
been made remove the
Step 3
Line up short beams with
markings and attach in place
using 2x100mm screws as
shown in the diagram.
Short beams should be
evenly spaced.
Step 4
Pre-Drill with
2mm bit
With the portbase in the
desired position for the
L shaped feet to the inside of
the portbase framework using
3x40mm round head screws
pre-drilling with a 2mm drill bit.
Ensure that the base is level. Either of
Step 5
To secure the base to the
ground, hammer in the spikes
at each corner untill level with
the top of the base, using a
piece of scrap wood to
prevent damage to the spike.
Once the Spike is in the desired
round head screws as shown. Pre-drill
using a 2mm drill bit.
Pre-Drill with
2mm bit
Step 6
*Important, for the 10x6 please leave
two of the short beams aside for addition
at a later stage.
