Assembly Instructions
11
Step
19
Note:
These can
also be round
O
N
+
N
O
15
14
O
y
y
x
x
y
y
x
x
Fit the back panels
a:
Square up the unit by
making sure that
measurement
x:x equals
y:y.
Place the short back
and long back ,
coloured surface facing
down, onto the unit as
shown.
Make sure that the 2
backs are pushed up
tight against each other
and that they meet in the
centre of the divider’s
back edge.
b:
Nail around the
outside edges of the 2
backs, as shown.
Note:
Do not nail the
edges where the 2 backs
meet.
c:
Push the nail screws
. through the back
holders and tap them
down between the short
back and the long
back and into the
back edge of the divider
. .
Keep tapping the nail
screws in until the
back holders dig into
the short and long back.
Carefully stand the
unit up for the next
step.
b:
M
The measurement from top corner X to bottom corner X must be
equal to the measurement from top corner Y to bottom corner Y
a:
15
14
14
15
3
M
c:
O
N
14
15
3
O
N
Warning:
The
unit is heavy.
Lift with care.
Do not nail the edges
where the 2 backs meet.
15
14
