Safety and Care Advice
Important
– Please read these instructions fully before starting assembly
1
.
Check you have all the
components and tools listed on
pages 2 and 3.
.
Remove all fittings from the
plastic bags and separate them
into their groups.
.
Keep children and animals
away from the work area, small
parts could choke if swallowed.
.
Make sure you have enough
space to layout the parts before
starting.
.
Do not stand or put weight on
the product, this could cause
damage.
.
Assemble the item as close
to its final position (in the same
room) as possible.
.
Assemble on a soft level
surface to avoid damaging the
unit or your floor.
.
We do not
recommend the
use of power
drill/drivers
for
inserting screws,
as this could damage the unit.
Only use hand screwdrivers.
.
Parts of the assembly will be
easier with 2 people.
.
Dispose of all packaging
carefully and responsibly.
This product contain
Natural timber; you may
notice some variation in the grain
and colour of different component
parts which is normal for furniture
produced using natural wood and
is not the result of any
manufacturing fault.
.
Care and maintenance
.
.
Avoid placing the furniture in
direct sunlight as this will cause
the timber to prematurely age.
Use an appropriate furniture
polish for natural wood
furniture and a dry cloth to
clean the product.
.
From time to time check
that there are no loose
screws on this unit.
.
This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre.
1 - DO NOT LEAVE THE CHILD UNATTENDED
2 - THIS PRODUCT IS INTENDED FOR CHILDREN WITH A MAXIMUM WEIGHT OF 15KG.
3 - PERIODICALLY CHECK AND ENSURE THAT ALL COMPONENTS ARE IN THEIR PROPER POSITION, FREE FROM
DAMAGE, AND THAT ALL ASSEMBLY FITTINGS ARE TIGHT.
4 - DO NOT USE THE PRODUCT WHEN ANY PART IS BROKEN, TORN OR MISSING.
5 - DO NOT USE SUBSTITUTE PARTS. CONTACT THE RETAILER FOR REPLACEMENT PARTS.
6 - BE AWARE OF THE RISK OF OPEN FIRES AND OTHER SOURCES OF STRONG HEAT, SUCH AS ELETRIC
BAR FIRES,
GAS FIRES ETC. IN THE NEAR VICINITY OF THE CHANGING UNIT.
7 - PLEASE ENSURE THAT THE CHANGING PAD USED DOES NOT EXCEED
73,0 X39,5 X 8,5 CM AND FITS WITHIN THE
BARRIERS WITHOUT FOLDING.
EN 12221-1:2008
Note:
if required the next page
can be cut out and used as
reference throughout the
assembly. Keep this page with
these instructions for future
reference.
Warning !
