Polystyrene
block
Assembly Instructions
Use 2nd hole in from front of
Runner F1004 to fit 1st F73 then
fit other F73 to match other hole.
Rebated Edge
F73
COVERED EDGE
Use 2nd hole in from front of
Runner F1004 to fit 1st F73 then
fit other F73 to match other hole.
F1004
When you insert F900,
make sure the arrow is
pointing towards the hole
in the edge of the panel.
F900
F73
F1004
COVERED EDGE
9
Step
17
Step
7
Fit the top
Note:
To make it easier
to fit the top panel, place
polystyrene blocks from
the packaging
underneath the side
panels to raise the
assembly.
Position the top onto the
unit, making sure that
the back edge of the top
is flush with the back
edge of the sides.
Secure the top using
screw through the 2
brackets fitted at the top
edge of the side panels.
H
F
100mm
100mm
500mm
F
H
H
H
3
Fit the 2 rails and
plinth
One at a time, push the 2
rails and plinth
onto the right side as
shown.
Use a screwdriver to
tighten the 3 large
locking nuts fitted to
the 3 panels, as shown.
Note:
Turn the large
locking nuts as far as
they will go - more than
1/2 a turn.
Note:
Support the rail
near the back edge of
the unit until the left side
has been fitted in the
next stage.
2
5
5
6
5
6
2
C
Step
18
Fit the left side
Push the left side
onto the assembly.
Use a screwdriver to
tighten the 5 large
locking nuts fitted to
the base , rails
and plinth .
Note:
Turn the large
locking nuts as far as
they will go - more than
1/2 a turn.
5
6
6
1
4
C
5
5
1
4
C
C
Support
this rail
