Assembly Instructions
Step
16
11
Drill the handle holes
in the doors
Important:
Only carry
out this step if the
hinge plates have been
fitted to the left side.
Lay the small door
and large door down
onto a smooth surface.
Important:
Carefully
choose which holes you
need to drill.
Check that the holes and
hinges are in the same
place as the diagrams.
Note:
We recommend
the use of a small piece
of waste wood, placed
behind the hole while
drilling, to reduce the
possibility of any
breakout.
Using the pilot hole in
the rear face of the doors
. and drill through
the holes indicated
opposite, using a 2.5mm
diameter drill.
Turn the doors and
. over and open out
the 2.5mm holes that
you have just drilled by
drilling back through
them with a 5mm drill.
6
7
Small piece of
waste wood
Drill these 2 holes in
the small door if you
have fitted the hinges
to the left side.
ONLY drill
these 2 holes
Carefully choose which 2 holes you will need to drill in each door.
This page shows the holes to drill if you
have fitted the hinges to the left side.
Do not carry out this step if you have fitted
the hinges to the right side, go to step 17.
DO NOT
drill these
holes
Drill these 2 holes in
the large door if you
have fitted the hinges
to the left side.
Small piece of
waste wood
ONLY drill
these 2 holes
DO NOT
drill these
holes
6
6
7
7
1
6
7
6
7
1
