Assembly Instructions
15
Step
26
Fit the back panels
a:
Square up the unit by
making sure that
measurement
x to x
equals y to y.
b:
Place the 2 backs
coloured surface facing
down, onto the unit as
shown.
Make sure that the 2
backs are pushed up
tight against each other
and that they meet in the
centre of the centre
divider’s back edge.
Nail around the
outside edges of the 2
backs .
Note:
Do not nail where
the 2 backs meet.
Nails should be spaced
out evenly.
c:
Push the 6 nail
screws through the 6
back holders and tap
them down between the
2 backs and into the
back edge of the centre
divider .
Keep tapping the nail
screws in until the
back holders dig into
the small and large back.
C
The measurement from top corner X to bottom corner X must be
equal to the measurement from top corner Y to bottom corner Y
a:
y
x
y
y
x
b:
C
17
17
3
17
Warning:
The
unit is heavy.
Lift with care.
17
17
c:
M
N
9
10
N
W
X
17
17
X
X
W
+
c:
W
X
17
3
W
X
Stand the unit up for
the next step.
Note:
These can
also be round
