P 6
Please retain product label and instructions for future reference
Please retain product label and instructions for future reference
Step 8
Place both of the roof sections
on top of the building, ensure
roof framing slots over each
side.
Fix the roof saections into
position using 40mm screws
ensuring to line up with the
vertical framing inside the
building and the internal roof
support bar
24x40mm Screws
Pre drill
hole
40mm
screw
Step 9
Fix the panels onto
the floor using
50mm screws in
alignment with
the floor joist.
20x50mm Screws
Pre drill
hole
40mm
screw
Felt
tacks
370cm
100cm
20cm
20cm
20cm
230cm
110cm
1
2
3
4
5cm
5c
m
5c
m
Fro
nt
Step 10
Cut three strips from roll of felt,
2x370cm and 1x230cm.
With one of the 370cm strips,
trim a corner off at 110cm to
make piece 1.
Place felt on top of roof sheet
and align as shown in diagram
ensuring each strip overlaps the
next by 20cm. Ensure all strips
over hang roof by 5cm.
Ensure strip 1 is the first piece
placed down then lay sheet 2, 3
and then 4 on top.
Cut the sides as shown in
diagram at the dotted lines, use
fascia width as guide for
overhang. Cut Triangle with
50mm overhang again using
fascia as a guide.
Fix each sheet using felt tacks
along where sheet overlap.
100x Felt Tacks
9
9
