3.4 For an inclined position, use the
swivel assembly (14).
STEP 1 : Swivel assembly content:
1- Connector base (8)
2- Swivel spacer (14a + 14b)
3- Swivel screw (14c)
4- Swivel square nut (14e)
Assemble the unit and leave it
unscrewed, just enough to allow
adjustement and also allow to turn the
swivel 90 degrees to have access to the
bottom hole to fix the flat head screw
at 6Nm. Once the proper angle is set,
use a marker to obtain a reference and
ajust both spacers with same angle. Use
the Di2 hole as a starting point.
Fix the 6mm flat head of the swivel
screw (silver) to 8Nm.
STEP 2 :
The connector base must be fixed to
the top of the swivel assembly, not on
the sleeve nuts. The sleeve nuts will be
used to fix the spacers later.
11
E-118 NEXT 216A: 3. Handlebar installation (continued)
1
2
4
3
GREASE
GREASE
5Nm
5Nm
8Nm
6Nm
5Nm
5Nm
5Nm
CARBON FIBER
ASSEMBLY
COMPOSITE
LOCTITE
