V 05/18
19
HOW TO USE THE CONVECTOR
Connect the power cord to a suitable electric socket (220-240V~/50Hz).
ON/OFF switch
(on the right side)
Bring the on/off switch to the “I” position.
When the appliance emits a beep this means that the convector is ready for use.
Bring the switch to the “O” position to switch off the convector.
CONTROL TOUCH PANEL
MODE button
Touch this button to regulate the heating mode:
-
Eco (750W)
-
Comfort (1500W)
TEMPERATURE button
Internal temperature is displayed every time
the appliance is started up.
When the appliance is in stand-by or
heating, touching this button
will allow you to
set the temperature: the display will show
ambient temperature and,
by touching this
button, the desired temperature can be set
between 16 and 40°C. Once the desired
temperature has been set, wait 5” for the
setting to be confirmed. After 5” the display
will show the ambient temperature once
again. The set default temperature is 25°C.
When room temperature is 2 degrees over
the set temperature, the appliance will stop
operating. The machine will begin operating
again only when temperature decreases 2
degrees with respect to the set temperature.
TIMER button
When the appliance is operating, the
operating time can be set by touching
this button: the timer display shows a
flashing 0 and touching TIMER you
can set the desired time, between 1
and 24 hours, with each touch
corresponding to an hour.
The display shows the set time: wait
5” for the setting to be confirmed. The
unit will switch off automatically at the
end of the programmed time (stand
by).
In order to switch it on again press the
button ON/OFF.
If a TIMER is set the LED remains
on.
ON/OFF buttons
Touching the ON/OFF button will cause the
LED to
light and the appliance will begin to operate.
The display will show ambient temperature.
The heater is working at low power heating
conditions.
To switch off the convector completely, place the on/off
switch in the “OFF” position.
Led display
